Ditto X4 Never completes firmware update, then all lights green
I have followed all of the instructions to update the firmware. Using a Macbook, the Ditto X4 is recognized immediately and the firmware update process starts. Once the uploading firmware reaches 100%, the updater application reads to wait for the lights to go orange, red, orange, red and then off. This never happens. I’ve tried the process 3 times and waited an hour the last time and it just never happens.
When I power on the pedal after this, the lights will all be green and it will be stuck. If I hold down Loop 2 while powering on, then it seems to boot normally. However, did the firmware update or did it not update? AFAIK there is no way to tell.
Source: http://forum.tcelectronic.com
