Modifying HT Dual distortion pedal for G System to switch with patches
I’ve recently switched amps from a Peavey classic to a Blackstar Artisan. I’m using a G system effects pedal and this was previously configured to switch between the clean and dirty channels of the Peavey.
In order to achieve a heavier overdrive with the Artisan, I’ve recently purchased an HT Dual distortion.
I need to modify the HT pedal, so that when I change patches on the G system, it will switch the pedal between, non-active (clean), 1st channel (dist) and 2nd channel (lead).
The two foot switches on the HT, are latching six pin switches (pcb mounted) which I am proposing to solder to a 1/4
Source: http://forum.tcelectronic.com
